series 28 hi per -d a ccess or ies e b and aster? ats tool an d b ands 1 band installa tion t oo l. u se with .240" (6.10 mm) wide bands. 6.75 inches (172 mm) length, 1.2 pounds (0.6 kg.) 1 2 standard band, .240" (6.10 m m) wi de. avai la ble 2 figure description part number band installation tool figure length part number a cc ommodates diameter in. mm flat pre-coiled in. mm contact glenair or visit our website (glenair.com) to view our complete line of band-master? ats products, including pneumatic tools for high volume production and calibration kits. tail length indicator mark .240 (6.10) .350 (8.9) length .060 (1.5) band -master ? at s t ool a n d ba nd s f or t ermi nation of ca bl e br aid 600- 058 t ool, 600- 052 and 600- 090 band st raps 1. prepare c ab le bra id for term in ati on process (figure 1). 2. push braid forward over adapter retention lip to the adapter incline point (or .4" [10.2mm] minimum braid length). milk braid as required shield termination area (figure 2). 3. prepare the band in the following manner: im po rt an t: due to co nn ector/a dapt er circum- ference, it may be necessary to prepare the band around the cable or retention area. a. roll band through the buckle slot twice. (bands must be double-coiled.) b. pull on band until mark ( ) is within ap- proximately .250 inch (6.4mm) of buckle slot (figure 3). the band may be tightened further if desired. note: prepared band should have ( ) mark visible approximately where shown in figure 3. shield termination cla mpi ng pr oce ss ( figu res 4 th ru 8 ) note: to free tool handles, move holding clips to center of tool. 4. squeeze gripper release lever and insert band into the front end opening of the tool. (no te: cir cul ar port io n of loope d ba nd m ust always face downward.) 5. aligning the band and tool with the shield terminati on area, squ ee ze blac k p ull -up handle repeatedly using short strokes until it locks against tool body. (this indicates the band is c ompr es sed to the t ool pr ecalib rated tension.) note: if alignment of band and shield is un- satisfactory, tension on band can be relaxed by pushing on slotted release lever on top of tool. make adjustments as necessary and again squee ze black pull-up handle. 6. complete the clamping process by squeez- 7. remove excess band from tool and dispose. 8. inspect shield termination. b and aster? s hiel d ter min ation i ns tructions 1 3 5 7 buckle tail length indicator mark adapter retention lip conductors braid adapter incline 2 4 6 8 .400 (1.2mm) min. length braid over termination area band- m ast er? ats 300 se ri es s st/passivat e i .a.w . ams 2700. the band -mas te r? ats wi th jus t one ban d s ize . a pp roved f or aer os pac e and defe nse , th es e s traps have succ es sf ull y pas se d r igo ro us shock , vib ra tion and e nviro nm enta l te st ing.
|